Take the 2-minute tour ×
Arqade is a question and answer site for passionate videogamers on all platforms. It's 100% free, no registration required.

This is my current minetrack setup. The red marked part is supposed to go up, such that it works as a booster.

On the left handed side you can see a wire going to the other track that is behind the booster - when it gets triggered (as in the image), the booster track magically resets and disables itself.

Other than wiring a different way, is it possible to prevent that behaviour?

share|improve this question

1 Answer 1

up vote 9 down vote accepted

I'm afraid not. The current triggers the neighboring blocks to update, which resets the slope of the track. Simply move the wiring (and what it connects to) one block further.

share|improve this answer
    
Thanks! But this won't trigger the shunt, right? –  fjdumont Feb 24 '11 at 17:40
    
@fjdumont Obviously :) Fixed. –  badp Feb 24 '11 at 17:41
    
You could also trigger the track piece with a redstone torch underneath it, and invert the signal from your input using a NOT gate. –  Kevin Y Feb 24 '11 at 17:42
    
@Kevin The blocks will still be updated at the next current change. –  badp Feb 24 '11 at 17:44
    
Ahh, I misinterpreted the problem. –  Kevin Y Feb 24 '11 at 19:35

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.