Take the 2-minute tour ×
Arqade is a question and answer site for passionate videogamers on all platforms. It's 100% free, no registration required.

I have a wireless Xbox 360 controller with its USB charger. Can I use it as a wired controller to play on my PC without buying the wireless receiver for Windows?

And if so, where can I find the drivers for Windows 7 64-bit (if available)?

share|improve this question
    
Hmm. I was going to say no, but the fact that it's an XBox controller complicates it. Microsoft might have left in the USB controller for all I know, rather than making it charge-only. –  Matthew Read Mar 17 '11 at 17:26
    
possible duplicate of Using a wireless XBox 360 controller on a PC –  kotekzot Oct 18 '13 at 7:36
add comment

3 Answers 3

up vote 14 down vote accepted

There is no way. Microsoft made it so the Play and Charge Kit only receives power. I believe there is some other data that is sent to the controller as well that someone decoded but there is no data sent to the computer from the controller. I will try to dig up a link.

On the other hand, you could just buy a wired controller, those are about as expensive as the wireless receiver, work on both PC and Xbox/Xbox360, and you'd have an extra controller for a friend.

share|improve this answer
    
Thank you... thats a good tip regarding buying a wired controller! –  WeekendWarrior Mar 17 '11 at 18:29
    
I use a wired controller for this use, and I know others that do too. Occasionally they go on sale on Woot or other places, so it is possible to bargain shop. –  EBongo Nov 2 '12 at 11:52
1  
Although buying a USB wired controller (USD $25 - $35) may be cost effective, I should point out that buying one USB wireless receiver (~$20 USD) supports connecting up to 4 xbox wireless controllers. So if you already have the wireless controllers this would be the better option. –  Michael Butler Nov 7 '12 at 20:55
add comment

It is possible, if you have an old junked xbox, you can rig it up with the 360 RF receiver and an old USB cable that you don't mind cutting up. after that a small change to the INF file for the drivers your all set using your wireless 360 controller on your pc. Also on a side note, when I first attempted this I didn't compensate for voltage and ended up seriously damaging the usb controller, so don't attempt unless you know a bit about it. Not going to post a how to tutorial here but, you can find near anything on the net. =]

share|improve this answer
add comment

protected by Community Nov 2 '12 at 9:31

Thank you for your interest in this question. Because it has attracted low-quality answers, posting an answer now requires 10 reputation on this site.

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.