Take the 2-minute tour ×
Arqade is a question and answer site for passionate videogamers on all platforms. It's 100% free, no registration required.

I noticed that giga coasters in RollerCoaster Tycoon 3 can have cable lift hills. Instead of a chain running the length of the hill, a train-length cable travels from the top of the hill, picks up the train from the station, carries it back up, and drops it off the other side.

What's the point to this, though? Does it have any advantages over traditional chain lifts?

share|improve this question
    
Fixed the tag for you. - ♪ –  Raven Dreamer Jul 25 '11 at 0:06
    
@Raven Thanks. I wonder why that didn't show up in the list. –  Maxpm Jul 25 '11 at 0:20
2  
perhaps it would be better stated as: "Created a tag for you. - ♪ " –  Raven Dreamer Jul 25 '11 at 0:59
add comment

2 Answers 2

up vote 8 down vote accepted

As Maxpm hinted at in his comment, it's mostly an issue of speed. A cable lift is faster than a chain lift, so the coaster gets to the top faster. I don't think there's any major gameplay reason to have one over the other, though a cable lift would likely shorten the ride time and thus might effect ratings. One would have to build two coasters that are otherwise the same to test the effects.

In terms of gameplay: It's been a while since I've messed around with Rollercoaster Tycoon 3, but if I remember right, cable lifts require a special start and end piece, and requires a completely straight lift hill. This means you need a certain amount of horizontal space to be able to use it successfully, and ideally, it should be used for the main starting hill. I'm not 100%, but you might be limited to only one cable lift start/end point. Chain lifts also only work on straight inclines, but you can add tight turns between them to break up the lift hill and make it spiral (though you need a certain train length to be able to do this). So chain lifts work well in areas with space limitations.

Outside of the game: Cable lifts are used in a variety of coasters and (according to wikipedia) they require less maintenance, and are fairly quiet compared to the loud, clanking chain lift. The earliest coaster to use a cable lift (at least, per the wikipedia article) was built in 2001, though the method was likely used prior to that. Rollercoaster Tycoon 3 came out in 2004 (with RCT2 coming out in 2002, and RCT1 coming out in 1999). Likely, the cable lift in RCT3 was included for realism and ride variety as opposed to any major gameplay reason.

share|improve this answer
add comment

You can use it with the higher degree angle! So you can climb 200 feet in almost no time at all.

share|improve this answer
    
You can do this with some chain lifts, too, albeit slightly slower. –  Maxpm Jul 25 '11 at 3:52
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.