Take the 2-minute tour ×
Arqade is a question and answer site for passionate videogamers on all platforms. It's 100% free, no registration required.

What is the best circuits for flashing lights with repeaters ? I've seen old school way with redstone but now with the repeaters, how to do it right ?

share|improve this question
    
Before I answer the question, are you referring to a row of flashing lights, or simply how to make one Redstone Torch oscillate on and off? –  Kevin Y Aug 21 '11 at 23:14

3 Answers 3

up vote 9 down vote accepted

With Redstone, there isn't really a right or wrong way to do anything. Here is one simple technique you can use to create flashing lights.

In this image, the part of the circuit at the bottom is known as a clock. It switches the Redstone Torch connected to the block from the on and off position. When the torch is off, no power is sent to the repeaters. This allows the torch to turn on. Then, the "on signal" travels through the repeaters and turns off the torch. This pattern repeats infinitely.

The signal is then sent to the repeaters in the hole I made. When power is sent through the repeaters, the block in front of them becomes "powered". This turns off the Redstone Torches mounted on each of those blocks, and in turn, alternates the Redstone Torches on the surface on and off.

enter image description here

share|improve this answer
    
Nice ! Thanks a lot –  Warface Aug 21 '11 at 23:31
2  
There are at least a few wrong ways to do it... –  fredley Dec 23 '11 at 10:59

One thing you can do is using redstone lamps you can wire it up in a complete circle say around the roof of a building, with the lamps in the corners of the building. You wire it up in this row and in the middle there is a circle of redstone and redstone repeaters. You break the redstone on the right bottom hand side and place a redstone torch and then immediately break the torch and place down the redstone dust. This in turn (as long as you've wired it up correctly) make a circuit that is in a repeating pattern.

share|improve this answer

Like this:

B = a block of whatever
W = redstone wire on the ground
T = A redstone torch
R = repeater

TB  <- torch connected to the side of the block
RW
WW

enter image description here

share|improve this answer
    
Did not worked! –  Warface Aug 21 '11 at 23:22
3  
@Warface Did you orient the repeater the correct way? The signal should be flowing from the Redstone Torch into the Redstone Dust. –  Kevin Y Aug 21 '11 at 23:25

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.