Take the 2-minute tour ×
Arqade is a question and answer site for passionate videogamers on all platforms. It's 100% free, no registration required.

I've found that digging around a river or stream to change its shape greatly decreases my frame rate. Would pumping out some water have the same effect, if I stop the pump afterwards?

share|improve this question

1 Answer 1

up vote 6 down vote accepted

If the water you pump out does not move around a lot, it should have no appreciable effect on FPS after the riverbed fills back up to capacity.

To maximize FPS, try to make sure there are no partial water tiles (below 7/7), though that could be difficult if you're going to be using the water. Minimizing the surface area of the reservoir could lead to lesser number of partial tiles moving around, though the benefit is likely to be minimal in common scenarios (Surface area of 100 tiles or less).

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.