1

I saw this question asking for the same thing and tried it on PE, but it didn't work. I put execute @a[x=11, y=4, z=0, r=1] ~ ~ ~ tp @p 11 4 -2 in a repeating command block, but it ignored the x=11, y=4, z=0 and r=1 and constantly kept teleporting me even though I was not on x=11, y=4, z=0. If it is possible, how would you teleport players that are on specific coordinates?

I am on single player and on version 1.1.5.

2

The x, y and z arguments in the target selector only move the origin of where to search for players, you still need a radius (r) or range (dx, dy, dz).

Also you don't need execute in this example, you can just put the target selector in the `tp' command.

So your command could for example look like this:

tp @a[x=11,y=4,z=0,r=1] 11 4 -2

A tip for dealing with repeating command blocks with teleport commands in them: In case anything goes wrong and you're stuck in a teleporting loop, write down the coordinates of the repeating command block beforehand and if it's out of control, execute the command /blockdata <coordinates> {auto:0} to stop it.

  • 1
    I forgot to add I did use r=1 in my command. /blockdata is not available in PE, but I could use /setblock X Y Z air to get rid of the command block. – cherryblossom Aug 27 '17 at 11:00

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.