4

I created one complex rails layout design with signals for faster traffic.

I wish to put same layout on another station (use it whenever I have similar stations).

Can I save a particular design block and snap it on an area so I do not have to build it again and again ?

3
  • I'm fairly certain that this isn't possible.
    – TZHX
    Nov 5, 2013 at 9:30
  • I asked about this on the OpenTTD forums years ago but the devs rejected it. I'm fairly sure there was a patch you could add to enable this though. It was a bit buggy - I'll try and find it.
    – tombull89
    Nov 5, 2013 at 9:45
  • @tombull89 this is answered properly by TeraTon below. Check it out.
    – PShah
    Nov 8, 2013 at 5:44

1 Answer 1

4

AFAIK in vanilla openTTD this isn't possible, but there is a grf(MOD) that enables this available in openTTD forums here

4
  • Thanks, I got the MOD there. Not tried it out yet. Sorry can not add +1 to your answer due to lack of reputation. Hope they can allow orig questioner to do it for helping.
    – PShah
    Nov 8, 2013 at 5:41
  • 1
    You should be able to mark the question as answered, that's different from +1.
    – TeraTon
    Nov 9, 2013 at 14:02
  • You get points for marking it answered. I also give you points for the question since it's a good one and i'm very interested in the mod as well.
    – Madmenyo
    Nov 15, 2013 at 14:30
  • Ticked answer as solution. As I could not up-vote, I didnt try tick mark also on assumption of similar treatment of it. Thanks.
    – PShah
    Nov 26, 2013 at 2:49

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .